Advisory & Compliance
From healthcare waste to a demonstrably controlled process
SimpleComply defines what each site needs for validation, permitting, business case, implementation and lifecycle management.
Your project, clearly structured
Three routes, one project plan
Start where your project is today. We connect compliance, finance and execution in one plan.
01
Compliance & Validation
- Map waste streams and acceptance conditions
- Translate risk assessments and biological hazards into work instructions
- Define validation, cycle registration and permit checks
Output: site-specific validation and compliance file.
02
Business Case & Financing
- Size capacity to volume, composition and peak load
- Map installation, operating and logistics costs
- Compare purchase, financing and Sterilwave leasing
Output: substantiated business case for decision-making.
03
Implementation & Lifecycle
- Prepare site, installation and commissioning
- Train staff and embed practical work instructions
- Organise preventive maintenance and process optimisation
Output: operating plan for reliable daily use.
Sterilwave in numbers
Independent validation and product family performance
Capacity and reduction vary by Sterilwave model, waste type and composition. Independent validation results apply to the tested configuration and test conditions; for each site we assess the relevant waste stream and operating conditions.
Why microwave treatment works
Sterilwave combines mechanical shredding with controlled microwave heating in one automated cycle. This creates a controlled process that brings microbial inactivation and process recording together.
Rotating blades reduce the waste and increase the exposed surface area for effective heat transfer.
The automated cycle takes approximately 30 minutes and heats the material to a maximum of 110 °C, without a pressure vessel, process water or chemicals.
The independent IRM test series demonstrates 7.41-8.68 log10 microbial reduction. Cycle data are recorded for traceability.
Our 6 steps
From analysis to demonstrable control
Define the waste stream
Volume, composition and risk fractions.
Check site conditions
Risk assessment, acceptance and permits.
Build the business case
Capacity, costs and financing.
Document validation
Criteria, test plan and evidence file.
Commission the process
Installation, training and maintenance.
Monitor & improve
Performance, waste route and costs.
Ready for the next step?
Make your waste stream, risks and business case concrete
In an initial consultation we identify the route and data required for your site.
